Skilled procedures labs run every week. Opt in the sessions you choose; contributors will be paid per approved hour once the program opens.
Assemble guide RNA and Cas9, electroporate primary cells and plate them for recovery.
02Remove a BGA with hot air, reball it and reflow it onto the board.
03Fragment, end-repair, ligate adapters and run bead clean-ups for a sequencing library.
04Drag-solder a 0.4 mm-pitch QFN and inspect for bridges under the microscope.
05Serial-dilute standards, load a 384-well plate and seal it for the cycler.
06Power a new board in stages, measure every rail and chase down a short.
07Break up Matrigel domes, split organoids and re-embed them.
08Probe high-speed lines on a scope and characterize ringing, skew and timing.
09Stain a multicolor panel with live/dead dye, FMO and compensation controls.
10Cast PDMS on a master, punch ports, plasma-bond to glass and leak-test.
11Lyse, bind on Ni-NTA, wash, elute and check fractions on a gel.
12Spin-coat, bake, expose and develop a photoresist pattern on a wafer.
13Run the gel, transfer to membrane, block, probe and image.
14Ball-bond a die to its package and pull-test the bonds.
15Dissociate cortical tissue and plate neurons on coated dishes.
16Cut, strip, crimp and pin a multi-connector harness, then continuity-test it.
17Transfect, select under antibiotic and pick single-cell clones.
18Calibrate a robot arm's kinematics and tool center point against fixtures.
Don't see your protocol? We want that too.
Join the data programRecordings belong to your lab. Nothing is shared unless you choose to contribute a session, and contributors get paid.
You choose each session. Everyone on camera agrees, and you can withdraw before anything ships.
Faces are blurred before a session leaves your lab.
Contributors will be paid for every approved hour once the program opens.